How to Install Delicate and Beautiful Mosaic?(10/31/2011)

Base surface treatment: pre-installation mounting surfaces should first ensure that the basic level, reserved for the installation location should be greater than the required thickness of mosaic 3-5MM. Paving should be done before a comprehensive clean-up work.

Pre-paving: paving according to the picture of construction before installation. When the acreage is too much, pave according to the numbers in the mosaic.

Paving: serrated spatula with the 2-3MM adhesive evenly to the basic wall, the appropriate thickness is 3-5mm. Pave the single piece of mosaic to the basic according to the design picture in the adhesive. The gap between the two, usually with each chip should be gaps between the pellets of the same. Put the planks flat on the surface of the mosaic, even beating with a rubber hammer to ensure strong bonding. In case of a mosaic pieces are too high or too low, you need to remove the piece to increase or reduce the adhesive.

Sealant: until the water dries and a moderate initial strength, use wooden or rubber spatula to pour into the mosaic cracks in the sealant. Start to clean up the surface when sealant are completed and the water has a moderate dry.
(Author Mosaic and Tile, China Leiyuan 10/31/2011)

Previous News:
Cautious Customers will not Suffer from the Inside Story of a Plot(10/30/2011)

Next News:
Foshan Ceramics Companies Set Up Factories in EU to Enhance The Added Value.(11/1/2011)